I just bought this and it's simply too big for me. I really want a Hot Rod or Rat Rod and something smaller than this. I had it shipped here (NC) from New Mexico so the body is straight. Price is CA$H price. I do not want any rice at all and also, no s-10's unless they are bagged/bodied AND v8 AND done ready to show. Would prefer not to half-trade and cash. Would rather trade outright for something nice and something that needs minimal work. I just got this truck about two weeks ago. The transmission leaks. It has a 700r4 in it. I have a rebuilt 700r4 with about 25 miles on it in a parts Astro Van that I use for my business, so I may end up putting that in. Let's assume it's in there because I will more than likely do it just so I know what's in it. There is no heat or a/c.It is stock floor body dropped and from what I can tell they did a great job. Doesn't get a lot of lift in the rear cuz I think they are Firestone bags. The guy I got it from said the bagged it about 2 years ago and finished the bodydrop in Spring of 08 and drove it from NM to Texas Heat Wave. (It has the sticker on the windshield) The body is completely shaved. Has a Full Phantom grille. Has a bumper with 6" fogs. There is no grille shell on it-it did not come with it, but I just ordered the parts so they will be here on Wednesday. It has a 4 link rear It runs on Nitrogen. Has 22" Akuza's (one has curb rash, but the alloy repair guy said it would cost $80 to fix) 350v8 carb'd. runs good. Manual hood release in fender well. Vent wdo for manual entry. Paint is a baby-blue primer. It's a real cool color, I have never seen it before. 99% of the bodywork is done. Put a rollpan on it and spend a weekend on it and paint it or just roll with the primer... tilt wheel. pwr wdo. (pass front wdo doesnt work. all others ok.) Has an Alpine radio, but I didnt check to see if it worked??? It has a broken windshield. The interior is all stock and needs to be covered and/or replaced cuz its older and outdated. There is no carpet because of the bodydrop. The notch cover is treated particle board. The old owner started making a metal cover but never finished it and didn't ship it with the truck. Needs new rubber. They all hold air, but they are dry rotted and need to be replaced. No rollpan, exhaust exits where rollpan is. He was going to make one with exhaust tips cut-outs. email me w/?
|